Licensed attic fire damage repair in MEDINA, Washington, from a crew that answers 24/7.

Attic Fire Restoration MEDINA WA: Soot, Smoke, and Structure Handled

Attic Fire Restoration MEDINA WA starts with stopping the damage from spreading and ends with your home smelling and testing clean. We handle attic fire damage repair in MEDINA, Washington for homeowners dealing with charred framing, melted wiring, soaked insulation, and smoke that has worked its way into every upstairs closet. Call (833) 929-6186 and we roll a crew to your door.

↗
Fast online booking

Request service today

Tell us what is happening. Our local team will confirm your visit shortly.

No spam. No obligation. Just practical help.
Thanks — we'll call shortly to confirm your visit.
Fire Damage Restoration near me in MEDINA, Washington
Careful work. Honest options.
About this service

What Attic Fire Restoration MEDINA WA Actually Involves

Attic Fire Restoration MEDINA WA is the licensed trade work of removing fire, soot, smoke, and suppression water damage from an attic and the living space below it, then rebuilding what cannot be saved. Attics are the worst place in a house for a fire to start. Heat and smoke rise, so the whole cavity bakes, and the same roof that kept rain out now traps soot against rafters, joists, and the back side of your ceiling drywall. We pull charred lumber, bag contaminated insulation, HEPA-vacuum every surface, and run air scrubbers until particle counts drop back to normal.

Most MEDINA attic fires we see start at an electrical junction, a recessed light, or a chimney chase that has gone too long without a sweep. The fire itself is often small. The damage is not. Firefighting water soaks the insulation batts, and within 48 to 72 hours you have the start of mold growth after fire suppression on top of everything else. That is why we treat attic fire damage repair MEDINA WA as a same-day job, not a next-week job. If you are searching for attic fire restoration near me in MEDINA WA at 2 a.m., we answer the phone.

  • ✓ Smoke Odor Gone, Not Masked
  • ✓ Structural Framing Saved
  • ✓ Air Quality You Can Trust
  • ✓ Insurance Paperwork Handled
What's included

What Our Attic Fire Restoration Service Covers

Every attic fire job is scoped to the specific damage, but here is what a standard restoration includes. If your loss needs something outside this list, we tell you before work starts, not after.

✓

Emergency Board-Up and Securing

Roof penetrations tarped, open windows boarded, and affected circuits shut off. This happens in the first two hours so the structure is not exposed to weather overnight.

✓

Soot and Char Removal

Charred drywall, lumber, and insulation removed and hauled off. Every remaining surface HEPA-vacuumed and wiped with soot sponges. This is the stage that stops the acidic residue from etching surfaces.

✓

Structural Drying

Industrial dehumidifiers and air movers set to dry the firefighting water out of the framing and subfloor. Moisture meter readings logged daily until the cavity meets dry standard.

✓

Air Scrubbing and Duct Cleaning

Negative air machines and air scrubbers run continuously to contain and filter contamination. HVAC ducts cleaned and sealed so smoke residue does not recirculate into bedrooms.

✓

Odor Neutralization

Hydroxyl generators and thermal fogging solution treat the cavities. Charcoal odor absorbers stay in place until the final odor check passes.

✓

Insulation and Rebuild

New insulation installed to current code, drywall hung and finished, primer and paint applied. Melted electrical wiring replaced and inspected before the attic is closed up.

How it works

How Our Attic Fire Restoration Process Runs

01

Emergency Board-Up

We arrive, secure the roof and any open penetrations, and shut off power to the affected circuits. This is the first 2 hours. You get a walkthrough of what we found, what we are doing, and what it costs before demolition starts.

02

Soot and Debris Removal

Crews in PPE pull charred drywall, bag fire-damaged insulation, and HEPA-vacuum every rafter bay. Soot sponges handle the light residue on adjoining ceilings. This stage usually runs 1 to 3 days depending on attic square footage and how far the smoke traveled.

03

Dry-Out and Air Cleaning

Firefighting water hides in insulation and subfloor. We set industrial dehumidifiers and air movers, run negative air machines to keep contamination contained, and scrub the air with HEPA filtration. Moisture meter readings are logged daily until the cavity is dry.

04

Odor and Duct Treatment

Hydroxyl generators run continuously while thermal fogging solution reaches cavities a sponge cannot. We clean and seal the HVAC ducts, then verify with an ozone generator cycle only where it is safe and unoccupied. Most homes pass an odor check within a week.

05

Rebuild and Final Walk

New insulation, drywall, primer, and paint go back in. We replace melted electrical wiring to code and hand you a photo record of every step. The final walk covers the workmanship warranty and the maintenance schedule so nothing surprises you in year two.

Tools & methods

Tools and Methods We Use on Attic Fires

Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.

Thermal Imaging Camera

Finds hot spots and hidden moisture behind drywall and inside rafter bays before we open anything. Keeps demolition targeted.

HEPA Vacuum and Air Scrubber

Captures soot particles down to 0.3 microns. We run air scrubbers continuously during demolition to keep contamination out of the living space.

Hydroxyl Generator

Neutralizes smoke odor at the molecular level in occupied and unoccupied spaces. Safe to run for days without the off-gassing concerns of ozone.

Industrial Dehumidifier and Air Mover

Dries the firefighting water out of framing and subfloor. Dri-Eaz and Phoenix Restoration Equipment units are our standard.

Moisture Meter

Logs daily readings so we know when the cavity actually meets dry standard instead of guessing.

Negative Air Machine

Keeps the attic under negative pressure so soot and dust do not migrate into the bedrooms below during demolition.

Soot Sponges and Encapsulant Sealer

Dry-cleaning for light residue and a sealing coat where the soot has etched into the surface. Fiberlock products are what we reach for.

Real results

Before and after.

Recessed Light Fire, Lake Medina Area

Before

A recessed light overheated and ignited the insulation around it. The attic was filled with soot, the ceiling below was smoke-stained, and the smell had reached the upstairs bedrooms. The homeowner had been told the whole attic ceiling would need to come out.

After

We removed the scorched insulation, cleaned and sealed the rafters, and replaced only the damaged drywall. Air scrubbers ran for four days. The final odor check passed on day six, and the ceiling was repainted to match. Total job: 9 days.

Chimney Chase Fire, South Court Street

Before

A chimney chase fire spread into the framing around the flue in a 1920s home. The charred structural framing was visible from the attic access, and firefighting water had soaked the insulation batts. The homeowner was worried the whole roof structure was compromised.

After

We opened the chase, sistered two rafters, replaced the charred framing, and installed new insulation with proper clearance to the flue. Moisture readings were logged daily for five days until the cavity was dry. The rebuild passed King County inspection on the first try.

Electrical Junction Fire, Downtown Medina

Before

An electrical junction box arced and started a small fire that the fire department put out with water. The attic was soaked, the wiring was melted, and smoke residue coated every rafter. The homeowner was told to expect a month of displacement.

After

We dried the structure in four days, replaced the melted electrical wiring to code, HEPA-vacuumed and sponge-cleaned every rafter, and ran hydroxyl generators for a week. The family was back in the house on day 11. Air sampling passed on the first test.

Problems we solve

Attic Fire Problems We Solve Before They Get Worse

The fire is out. The damage is not done. These are the problems that turn a contained attic fire into a six-month headache if nobody handles them in the first week.

Ask a pro →
01

Lingering smoke odor that returns in warm weather

We remove the contaminated insulation, treat the cavities with hydroxyl generators and thermal fogging, and verify with an odor check before the job closes. Attic smoke and fire cleanup MEDINA WA done right the first time is the only fix.

↗
02

Soot residue etching painted ceilings below

Our crew HEPA-vacuums and sponge-cleans adjoining surfaces within the first 48 hours. Where the residue has already etched, we seal with an encapsulant sealer and repaint.

↗
03

Mold growth after fire suppression water

We set drying equipment the same day and log moisture readings until the cavity is dry. If mold has already started, we treat it under the ANSI/IICRC S520 standard before rebuild.

↗
04

Smoke-damaged HVAC ducts recirculating contamination

We clean and seal the duct system, replace HEPA filters, and verify air quality with sampling before we call the job complete.

↗
Proof you can check

Licensed, Certified, and Documented

✓
IICRC Fire and Smoke Restoration Technician (FSRT)Institute of Inspection, Cleaning and Restoration Certification
✓
IICRC Water Damage Restoration Technician (WRT)Institute of Inspection, Cleaning and Restoration Certification
✓
EPA Lead-Safe Certified FirmU.S. Environmental Protection Agency
✓
OSHA 10-Hour Construction SafetyOccupational Safety and Health Administration
✓
Washington State Contractor LicenseWashington State Department of Labor & Industries
Good questions

Attic Fire Restoration Questions MEDINA Homeowners Ask

(833) 929-6186 →

Typical 2026 pricing for attic fire restoration in MEDINA WA runs $4,500 to $18,000 for a contained attic fire, and $25,000 or more when the fire reached the living space below. The range depends on attic square footage, how much insulation is contaminated, whether the HVAC ducts need cleaning, and how much framing has to be replaced. We give you a written scope before demolition starts.

Fire Damage Restoration Medina does, and we cover all of MEDINA and the surrounding King County area, including ZIP code 98039. We are licensed in Washington State, hold IICRC FSRT and WRT certifications, and answer the phone 24/7 at (833) 929-6186. Same-day attic fire damage repair in MEDINA, Washington is available for most calls before noon.

Usually no. Blown-in fiberglass and cellulose that has absorbed smoke or firefighting water cannot be cleaned effectively and has to be bagged and removed. Foam board and rigid insulation can sometimes be saved if the surface is intact and HEPA-vacuumed. We test with a moisture meter and make the call per bay, then replace with new insulation rated for your attic.

Yes, in most cases. A standard homeowner policy covers fire damage, smoke damage, and the water used to put the fire out, minus your deductible. We document the loss with photos, moisture readings, and a line-item scope so your adjuster has what they need. We work directly with all major carriers and can talk to your adjuster on your behalf.

Ready when you are

Get Attic Fire Restoration MEDINA WA Moving Today

Every hour that soot sits on framing and insulation makes the job bigger. Call (833) 929-6186 and a live person will schedule your crew, walk your attic, and hand you a written scope before demolition starts. Licensed, insured, and answering 24/7.

Call Now (833) 929-6186 →
Request an appointment

Contact Our MEDINA Fire Damage Restoration Team

Call (833) 929-6186 any hour of the day. Our line is staffed 24/7, and we dispatch same-day across Medina, Downtown Medina, and the surrounding King County townships. If you prefer email, send photos and your address to info@firedamagerestorationmedina.com and we will call you back within the hour.

Request received — our team will be in touch shortly.
Tap to call(833) 929-6186