Soot, smoke, and water damage handled by a crew that shows up fast.

Fire and Smoke Damage Restoration MEDINA WA

Fire and Smoke Damage Restoration MEDINA WA starts the moment we pull up: we stop the damage from spreading, pull out the soot, and get the smoke smell out of your walls, ducts, and furniture. Whether you need fire and smoke cleanup in MEDINA after a kitchen flare-up or a full attic fire, we handle the water from the hoses too. Call (833) 929-6186 and we roll.

↗
Fast online booking

Request service today

Tell us what is happening. Our local team will confirm your visit shortly.

No spam. No obligation. Just practical help.
Thanks — we'll call shortly to confirm your visit.
Fire and Smoke Damage Restoration
Careful work. Honest options.
About this service

What Fire and Smoke Damage Restoration MEDINA WA Involves

Fire and Smoke Damage Restoration MEDINA WA is the full-scope cleanup and repair process that starts after the trucks leave and ends when your home is safe to live in again. It is not just wiping down walls. Smoke pushes into every gap, so we test with a thermal imaging camera, pull charred drywall and insulation, treat framing, and run air scrubbers with HEPA filters to get the air clean. Soot sponges, encapsulant sealer, and thermal fogging solution come out next. The goal is simple: no smoke odor, no soot residue, no mold from the water the fire department left behind.

In MEDINA, most calls we get are kitchen fires, electrical fires in older wiring, and attic fires that start from a roof or chimney issue. The close-in lots and mature trees around Lake Medina Area mean a small fire can spread smoke into neighboring units fast. If you are searching for fire and smoke damage restoration near me in MEDINA WA at 2 a.m., we answer. Our 24/7 fire and smoke cleanup in MEDINA Washington line is staffed, not routed to a call center.

  • ✓ Stop the Damage Spreading
  • ✓ Odor Gone, Not Covered Up
  • ✓ Insurance Paperwork Handled
  • ✓ Water Damage Caught Early
What's included

What Our Fire and Smoke Damage Restoration Includes

Every job starts with a written scope, and the scope covers the work below. If something is not needed, it comes off the scope and the price drops. If something extra shows up mid-job, like hidden water damage behind a wall, we stop and talk to you before we touch it.

✓

Emergency Board-Up and Tarping

Windows, doors, and roof openings get sealed so weather and theft cannot add to the loss. We use plywood, roofing shingles, and heavy tarps, and we photograph everything before and after.

✓

Soot and Char Removal

HEPA vacuuming, soot sponges, and hand-wiping of walls, ceilings, and hard surfaces. Charred drywall, insulation, and lumber come out with a drywall saw and pry bar and get hauled away.

✓

Water Extraction and Drying

Firefighting water gets extracted with truck-mount units, then industrial dehumidifiers and air movers dry framing and subfloor for 3 to 5 days. We log moisture meter readings daily.

✓

Odor Treatment and Air Cleaning

Air scrubbers with HEPA filters run throughout the job. We finish with hydroxyl generators or ozone generators and thermal fogging solution, then verify air quality before the final walkthrough.

✓

Duct Cleaning and Sealing

Smoke settles in HVAC ducts and recirculates every time the heat runs. We clean the ductwork, seal gaps with duct sealing tape, and replace HEPA filters so the system does not undo our work.

✓

Structural Repair and Finishing

Drywall, primer, paint, and trim go back on after the structure is clean and dry. We handle the rebuild in-house so you are not coordinating a separate contractor.

How it works

What to Expect From Start to Finish

01

Emergency Call

You call (833) 929-6186 and talk to a real person. We ask what burned, how big the fire was, and whether the power is off. Within 60 to 90 minutes a crew is at your door with tarps, board-up materials, and extraction equipment. No waiting until morning.

02

Safety and Board-Up

First we make the structure safe. We check for compromised framing, shut off utilities if they are not already off, board windows, and tarp roof damage. This takes 30 to 60 minutes on a typical house and protects your home from weather and theft while the rest of the work happens.

03

Soot and Smoke Removal

We HEPA vacuum loose soot, then hand-wipe surfaces with soot sponges and specialty cleaners. Charred drywall and insulation come out with a drywall saw and pry bar. HVAC ducts get sealed and cleaned so smoke does not recirculate every time the furnace kicks on.

04

Dry-Out and Deodorize

Industrial dehumidifiers and air movers run for 3 to 5 days to pull the firefighting water out of framing and subfloor. Then we run ozone generators or hydroxyl generators, depending on occupancy, and thermal fog the structure. We verify with air quality testing before we call it done.

05

Repair and Walkthrough

Drywall goes back up, primer and paint go on, and trim gets replaced. We walk the house with you room by room, show you the moisture readings, and hand over the documentation package for your insurance claim. Most jobs close out in 2 to 4 weeks depending on scope.

Tools & methods

Tools and Methods We Use

Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.

Thermal Imaging Camera

Finds hidden hot spots, moisture pockets, and smoke travel paths inside walls and ceilings without tearing the house apart.

Air Scrubber with HEPA Filters

Runs continuously during cleanup to capture fine soot and smoke particles before they settle back on clean surfaces.

Ozone Generator and Hydroxyl Generator

Ozone for unoccupied structures, hydroxyl for occupied spaces. Both break down odor compounds at the molecular level instead of masking them.

Industrial Dehumidifier and Air Mover

Dri-Eaz and Phoenix Restoration Equipment units pull firefighting water out of framing and subfloor and speed drying to 3 to 5 days.

HEPA Vacuum and Soot Sponges

Loose soot gets vacuumed before any wet cleaning, and dry soot sponges lift residue off walls and ceilings without smearing it.

Moisture Meter

Daily readings document the drying progress and tell us when framing is actually dry, not just dry to the touch.

Negative Air Machine

Creates pressure differentials that keep soot and dust from migrating into clean rooms during demolition and cleaning.

Real results

Before and after.

Kitchen Fire Smoke Cleanup

Before

A grease fire scorched the cabinets and sent smoke through the first floor of a Medina Square home. Soot coated the ceilings, the range hood was caked in residue, and the smoke smell had settled into the living room furniture.

After

We degreased the cabinets and hood, HEPA vacuumed and wiped every ceiling and wall, cleaned the contents, and ran air scrubbers for 3 days. The smoke smell was gone at the final walkthrough, and the job closed in 6 days.

Attic Fire Structural Dry-Out

Before

An attic fire from a chimney issue charred framing and soaked insulation in smoke. Firefighting water ran down into the ceiling below, and moisture readings in the framing were high enough to risk mold within 72 hours.

After

We pulled the insulation, treated and sealed the framing, dried the roof deck and ceiling cavity for 4 days, and replaced materials. Moisture readings returned to normal, and the repair passed inspection in 3 weeks.

Electrical Fire Wall Cavity Cleanup

Before

An electrical fire in an older Downtown Medina home charred wiring inside a wall cavity and left smoke residue in the surrounding rooms. The wall had to be opened, and the smoke smell was noticeable on the second floor.

After

We opened the wall, removed char and residue, cleaned the cavity, ran hydroxyl generators for 2 days, and coordinated with the electrician. The wall was rebuilt and painted, and the claim documentation supported the full scope.

Problems we solve

Problems We Solve After a Fire

The fire is out, but the damage keeps moving. Here are the problems we see most often on MEDINA jobs and how we stop them before they cost you more money.

Ask a pro →
01

Lingering smoke odor in walls and ducts

We remove the soot source first, then run hydroxyl or ozone generators and thermal fog the structure. Ducts get cleaned and sealed. If odor returns within 30 days, we treat again at no charge.

↗
02

Soot residue etching paint and glass

We HEPA vacuum loose soot and hand-wipe surfaces with soot sponges and specialty cleaners within the first 24 to 48 hours. That window is what saves paint and glass from permanent damage.

↗
03

Water damage from firefighting hoses

We extract standing water and set industrial dehumidifiers and air movers immediately. Drying is documented to IICRC S500 standards with daily moisture meter readings.

↗
04

Smoke-damaged HVAC spreading contamination

We clean and seal the ductwork and replace HEPA filters before we finish the interior cleaning. That keeps the air clean after we leave.

↗
Proof you can check

Licensed, Certified, and Insured

✓
IICRC Fire and Smoke Restoration Technician (FSRT)Institute of Inspection, Cleaning and Restoration Certification
✓
IICRC Water Damage Restoration Technician (WRT)Institute of Inspection, Cleaning and Restoration Certification
✓
EPA Lead-Safe Certified FirmU.S. Environmental Protection Agency
✓
Washington State Contractor LicenseWashington State Department of Labor and Industries
✓
King County Business LicenseKing County
Good questions

Frequently Asked Questions

(833) 929-6186 →

Most MEDINA fire and smoke damage restoration jobs run $3,500 to $18,000 in 2026, with small kitchen fires on the low end and whole-house attic fires on the high end. Square footage, how far smoke traveled, whether water damage needs drying, and whether ductwork needs cleaning all move the number. We give you a written scope before any work starts, and we bill insurance directly when you file a claim.

We do. Fire Damage Restoration Medina handles fire and smoke cleanup in MEDINA, WA and across King County, including Downtown Medina, Medina Square, and the Lake Medina Area. We are licensed, insured, and IICRC FSRT certified. Call (833) 929-6186 and we will be on site within 60 to 90 minutes for emergencies.

A typical MEDINA fire and smoke damage restoration takes 2 to 4 weeks from board-up to final walkthrough. Small kitchen fires with limited smoke travel can wrap in 7 to 10 days. Whole-house fires with structural repair, duct cleaning, and full dry-out run 4 to 8 weeks. The drying phase alone takes 3 to 5 days, and we do not rush it because moisture left in framing causes mold.

Yes, most homeowner policies in Washington cover fire and smoke damage restoration, including soot removal, odor treatment, and water damage from firefighting. You pay your deductible and the policy handles the rest, up to your coverage limits. We document the loss with photos and moisture readings, work directly with your adjuster, and can usually bill the carrier directly so you are not fronting the full cost.

Ready when you are

Get Fire and Smoke Damage Restoration MEDINA WA Started

Smoke odor and soot get worse every hour. Call (833) 929-6186 and a real person answers, day or night. We are licensed, insured, and IICRC certified, and we will be at your door within 60 to 90 minutes with a written scope before any work begins.

Call Now (833) 929-6186 →
Request an appointment

Contact Our MEDINA Fire Damage Restoration Team

Call (833) 929-6186 any hour of the day. Our line is staffed 24/7, and we dispatch same-day across Medina, Downtown Medina, and the surrounding King County townships. If you prefer email, send photos and your address to info@firedamagerestorationmedina.com and we will call you back within the hour.

Request received — our team will be in touch shortly.
Tap to call(833) 929-6186